Visit our facebook page Visit our Youtube Channel
1300 560 042

Alsert Doors Information for the Trade

Alsert Doors technical information is available to assist with your design selection, quoting, ordering and installation process.

If you require any further information please don’t hesitate to contact us on 1300 560 042.

Click on the following links for further information:

 

Ordering Tips

  • When gas struts, HK, HL or HS lift systems are ordered, Box profiles are more cost effective than Flat profiles because adaptor blocks are not required.
  • HF lift system, sliding door mechanisms and sliding bi-fold mechanisms are not available in Flat profiles.
  • Alsert Doors will automatically configure the correct hardware for the application you select and the applicable maximum height, width and area are shown.
  • The number of hinges can be increased or reduced by one on a hinged door.

 

Integrated Clear Anodised Handles

The Alsert Doors integrated handle is now available in 3 sizes. These handles can be positioned anywhere on the door frame but no less than 60 mm from any corner on either the horizontal or vertical edge.

The handles are 197mm, 147mm and 35mm in length, in the clear anodised finish and are only suitable for Box profiles. Positional measurements are required for factory fitting.

The integrated handle is suitable for most hardware applications such as Lift Up Bi-folds, Hinged doors, Spring Flap doors, Up & Over doors, Sliding Bi-Fold doors, Microwave doors & Drawer fronts.

 

COLOUR MATCHING

Final installed painted doors may appear to vary from the colour selected.

The usual causes are: the colour is viewed through the glass, position, lighting, competing colours, glass type and processing conditions.

Due to differing thickness of glass, differences in reflective surfaces and the variance of cabinet materials to glass, we can not guarantee an exact colour match to other materials and other glass products.

We will only guarantee a match to our samples – no other claims based on colour variation will be accepted. These samples comprise those in our trade partner showrooms or requested at the time of ordering. 

 

OUR GLASS PRODUCTION INSPECTION GUIDELINES

Glass is to be inspected at an angle perpendicular [90 degrees] to the surface and viewed under natural light i.e. not in direct sunlight or under bright lighting. Clear or translucent glass is to be inspected from a viewing distance of 1.5 metres looking through the glass  to a point 1 metre behind the glass.

The general purpose of glass is to be looked through – not at. The above applies to mirrors in as much as mirrors are designed to show a reflection – not focusing on the surface.

Seeds, bubbles and spots smaller than 1 mm are acceptable in any number. Those inclusions that are between 1 mm and 3 mm are allowable as long as there is no more than 1 per panel.

Please Note:- Australian standards allow for inclusions up to 5 mm in diameter.

10 year warranty on Alsert Doors, 5 year warranty on Mirror Doors.

Download Alfresco Kitchen Brochure by Alsert Doors

As seen in
Kitchen & Bathrooms Quarterly

DOWNLOAD

Visit Tambortech Doors, our partner in tambour doors

Tambortech Doors
Our Partner in tambour doors

VISIT SITE

Download Alsert Doors Brochure

Download our flyer to show
your kitchen professional

DOWNLOAD